This HyperX HX430C15PBK4/32 is a kit of four 1G x 64-bit (8GB) DDR4-300 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA component per module. Each module kit supports Intel Extreme Memory Profiles (Intel XMP) 2.0. Total kit capacity is 32GB. Each module has been tested to run at DDR4-3000 at a low latency timing of 15-16-16 at 1.35V. The SPDs are programmed to JEDEC standard latency DDR4-2133 timing of 15-15-15 at 1.2V. Each 288-pin DIMM uses gold contact fingers.

Features:

• Power Supply: VDD=1.2V Typical
  
• VDDQ = 1.2V Typical
  
• VPP - 2.5V Typical
  
• VDDSPD=2.2V to 3.6V
  
• Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
  
• Low-power auto self refresh (LPASR)
  
• Data bus inversion (DBI) for data bus
  
• On-die VREFDQ generation and calibration
  
• Dual-rank
  
• On-board I2 serial presence-detect (SPD) EEPROM
  
• 16 internal banks; 4 groups of 4 banks each
  
• Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
  
• Selectable BC4 or BL8 on-the-fly (OTF)
  
• Fly-by topology
  
• Terminated control command and address bus
  
• Height 2.167” (55.05mm), w/heatsink